With the development of mobile technologies, many different interesting solutions have appeared that relate not only to the filling of devices, but also their form factors. In addition to the usual "candy bar" phones began to be produced in the "slider" format, which made it possible to make the device more compact, but complex in design.
Necessary
- - a set of screwdrivers for disassembling mobile phones;
- - double sided tape
Instructions
Step 1
First, open the back cover of the device and remove the battery. Remove the SIM card and flash drive. In Samsung sliders, you need to unscrew the 4 screws that connect the back panel to the board. For a Sony Ericsson phone, remove the two caps at the top of the case and unscrew the same screws.
Step 2
Open the slider slightly and unscrew 2 more screws that have opened, if present (depending on the phone model). For Sony Ericson, you need to slide out the keyboard by pressing on the side of it, and then unscrew the two screws to which you have access.
Step 3
Remove the battery compartment cover. Unscrew four more screws, 2 of which are covered with labels at the top (remove them carefully with a sharp knife).
Step 4
Remove the front panel that is held in place by the plastic clips. You can move them away with a light press.
Step 5
Remove the screw directly below the display. Lift the board responsible for navigation, under which there will be a ribbon cable connected to the board using connectors. Disconnect them using the clips.
Step 6
Remove the four screws and disconnect the ribbon cable connector. Remove the upper part of the slider from which you need to get the camera lens.
Step 7
Remove two more screws from the top of the battery compartment. Remove the plastic piece that is near the SIM slot. This will open access to the card reader loop, which can be disconnected by pressing the corresponding lever. Disconnect the reader and camera. The antenna can be disconnected using the clip in the lower right corner.
Step 8
Remove the keyboard cable that is attached to the double-sided tape. It will most likely have to be replaced. Easily bend the clamps of the board itself, disconnect the restraining cable, disconnect its connector, remove it from the case.
