Another novelty pleased Nokia users by releasing the Nokia 6500 slider. The bright appearance of the phone the size of a plastic card gives the impression of solidity and reliability thanks to the metal body. Only the lower and upper ends of the device are played with plastic inserts. All details fit together perfectly.
Necessary
star screwdriver, disassembly tool and flathead screwdriver
Instructions
Step 1
The slider opens very easily, thanks to the high-quality auto-eyeliner mechanism. There is a small stop for more comfortable opening at the bottom of the display. There is no gap between the blocks that make up the phone, so they fit perfectly together.
Step 2
On the left side of the device there is a hole for a lanyard, on the top right there is a metal key for volume control. At the bottom there is a button for turning on the camera, at the top there is an exit for a memory card and a headset, as well as a button for opening the back cover. On the back of the phone you can see a camera lens and a flash, an external speaker is located closer to the bottom.
Step 3
To disassemble the unit, you will need an asterisk screwdriver, a tool to disassemble the case, and a small flathead screwdriver. The tool for disassembling the case can be replaced with a screwdriver wrapped in a sheet of paper to avoid damage to the device. The back cover must be removed, take out the battery, memory card and sim card. After that, with a tool for disassembling the case or a screwdriver, you need to hold it around the upper plastic insert, gently pulling upwards, carefully remove this part.
Step 4
On the back of the phone around the camera there is a small cover, glued with double-sided tape, you need to pry it off and it can be easily removed. The metal window framing the camera should also be removed. After these manipulations, the upper part of the phone must be moved and the cover can be removed without much effort. Now you need a flat screwdriver to separate the screen from the case, first on one side, then on the other. Once it rises, you can remove it.
Step 5
Now is the time to unscrew the screws that hold the metal plate. When the cover is removed, you can see the matrix connector under it. To detach it, just pry it off with a flat screwdriver and pull up. The matrix can be easily removed with the frame and then removed from it. Next, you should pull on the antenna located on top, then remove the cable by slightly lifting it. After that, the motherboard is removed from the case. The phone is now completely disassembled.
