When purchasing a new remote control / remote control for your car, you will need to flash it. This is necessary to register the remote control in the car alarm system. You may need a new remote control in case of loss / malfunction of the old one, or if you want to have an additional remote control.
Necessary
- - remote control / keychain;
- - automobile.
Instructions
Step 1
Flash the remote control in the car, to do this, turn on the ignition, then press the lock button on the remote control for four seconds. Then turn off the ignition for 4 seconds. Repeat these steps twice more. Turn on the car ignition. Click on the lock button of the remote control within 4 seconds. Make sure that the electric door interlock has been activated. Do this action three times. This way you can register the remote control to the machine. In total, you can make up to three key chains.
Step 2
Use the following method to program your car remote. Please note that the memory of the remote control system can store the codes of three remote controls. If you enter the fourth, the first will be erased automatically. Do not exceed the allowed pause between steps. Before flashing the key fob, make sure all doors, trunk lid and hood are closed.
Step 3
Turn on the ignition of the car, turn the key to the ON position, then, after no more than four seconds, press the lock button, while aiming the remote control at the receiver, which is located near the main power window switch. Turn off the ignition for 1 to 4 seconds. Then do the above steps again. There should not be more than four seconds between switching on, pressing the buttons and switching off the ignition, otherwise you will not be able to program the remote control.
Step 4
Turn on the ignition, press the lock button, while aiming the remote control at the receiver near the power windows. Make sure you hear the sound of the lock mechanism. Press the lock button again. You then have ten seconds to program the remote controls you want to memorize.
Step 5
To do this, click on their close / open buttons. At this moment, the sound of the lock mechanism should sound. Switch off the ignition, remove the key. Make sure all remotes are working properly.
