When disassembling a mobile phone to replace its socket, you should be extremely careful. It would seem that actions that are simple at first glance can bring many problems in the future if they are performed incorrectly.
Necessary
Cell phone, small screwdriver, or kitchen knife
Instructions
Step 1
Initially, you must turn off your mobile phone by pressing the corresponding button on the device. After the mobile phone is turned off, remove its back cover and remove the battery from the device. After removing the battery, you just have to get out the SIM card, after which you can proceed to the next stage of disassembling the phone.
Step 2
On the body of the device, you will see small size fastening screws. You may need a small screwdriver to unscrew them (if you don't have the correct size screwdriver, you can use the tip of a kitchen knife as one). However, before you start freeing the phone case from the screws, perform a simple, but at the same time, quite important operation.
Step 3
Take a piece of paper and sketch on it the location of all the screws on the phone. Next, unscrewing each screw, place it on the corresponding mark on your diagram. After all the screws have been removed from the case, you will need to remove the cover from the mobile phone.
Step 4
The front panel is removed first. This is done using a connecting seam, which you can see along the perimeter of the entire end part of the device. Simply pull the front panel towards you, catching on the seam. Once the front of the case is removed, unscrew the circuit from the back and remove it. As in the previous case, you need to mark the correct location of the bolts on the paper. This diagram will be needed for the subsequent assembly of the mobile phone.
