Today, most people are trying to equip their home with beautiful, modern and high-quality household appliances, including glass-ceramic stoves, which are chosen by every second family. However, such plates require special installation and maintenance. Incorrect connection can lead not only to the termination of the warranty, but even to a fire.
It is necessary
- - tester;
- - copper three-core wire;
- - special socket for plates;
- - panel board machine;
- - pliers and screwdriver.
Instructions
Step 1
Unpack the stove. In this case, it is important to remove not only the outer films, but also the inner ones, which are in the oven. Remove any extra items from the oven and close the door tightly.
Step 2
Read the instructions carefully. Select the correct location for the hob in accordance with the recommendations given in the instruction manual. If you are going to install new kitchen equipment in place of the old one, then take care to prepare and clean the place for the new stove.
Step 3
Check the plate for connecting plates. The cable that goes to the apartment must have a cross-section of at least 6 mm², and the introductory machine must be 40-50A. Remember, the wire to the glass-ceramic electric stove must be separate; it is strictly forbidden to connect any other devices to it. The cable must have three conductors - one for zero, the second for grounding and the third for the phase.
Step 4
Route the cable and connect zero and ground to different connectors. In this case, zero is connected to a bus isolated from the body, and grounding to the body. The phase is connected to an automatic machine with a nominal value of 32-40A. If you are not an electrician, then it is best in this case to use the services of craftsmen.
Step 5
Pay attention that there is a 3-pin 25-38A socket on the opposite end of the wire.
Step 6
Install the outlet where the wires are connected. It can be purchased at any specialty store. Assemble the fork. As a rule, glass ceramic hob manufacturers do not install forks on their products.
Step 7
Take a PVA 3 to 4 cable of the required length for connecting the plate to the outlet, if one is not included in the kit. Connect the plate to it, paying attention to the colors of the wires (blue - zero, black - phase, yellow-green - ground). Turn on the machine in the input box. Insert the plug into a power outlet.
Step 8
Take a tester and check if all the actions with the outlet are correct. To do this, set the indicator of the device to 2 Mohm and if the infinity sign is shown on the screen, everything is done correctly. Slide the slab against the wall, if required.
