The remote control allows you to tune and change TV channels from a distance. Amino remotes can be programmed for any TV model, the setup procedure is different for each model.
It is necessary
- - remote control;
- - television.
Instructions
Step 1
Set up your Amino remote to execute a sequence of commands with one button press, i.e. assigning a macro to a button. Please note that it can be assigned not just to one button, but to the reaction of the button in one of two modes (TV or STB).
Step 2
To create a macro, press and hold both mode keys for two seconds. Then select the mode in which the button response will change and click the button for which you want to assign the macro. This way you can program the remote control to perform frequently used actions.
Step 3
Assign actions to the button. Press STB or TV, depending on which device you want to send the signal to. Then press any button you want to perform.
Step 4
Repeat these two points as many times as you want to record in the macro (no more than four). If necessary, add a pause after the action by pressing STB. Enable repeat macro while holding down the button with TV. To exit programming, press (STB) + (TV) at the same time.
Step 5
Set up the Amino remote to control your TV, to do this, press the TV button, it should light up red. Keep it pressed, wait until it goes out. Then click "OK". Do not release both keys until the TV button lights up again.
Step 6
Let them go. From the table on the website https://www.dsr.dn.ua/index.php/component/content/article/19/56-tuneaminopult.html, select the manufacturer of your TV, use the number buttons on the remote control to enter one their three-digit codes corresponding to your TV. After the end of the set, the TV button should automatically go out, press and release the "OK" button.
Step 7
Check the correctness of the code, for this use the VOL volume control key, before that switch the remote control to the TV control mode by pressing the TV key once. If there is no reaction to the buttons, repeat the third step again using other codes from the table.
