As a rule, if the control panel is lost or damaged, it is impossible to turn on the air conditioner. It is not always possible to buy a new remote control for a specific air conditioner model. Therefore, buying a universal remote control is the only way out. With the help of such a remote control, you can control any air conditioner. To do this, you need to configure the remote control for your air conditioner model.
The principle of setting up all remotes is the same and consists in entering the required code into the remote control memory. As a rule, an instruction is attached to the remote control, in which there is a table of codes for different models of air conditioners. There are two modes for setting up the remote control - automatic and manual.
Automatic mode can be used if you do not know which air conditioner you have or your air conditioner model is not listed in the code table. To set up in the auto search mode, you need to take the remote control in your hand and point it at the air conditioner. Find the "SELECT" button on the remote control, press and hold it for 5 seconds, then release it.
The remote control will automatically send commands to the air conditioner and cycle through all available codes. In this case, the codes on the display of the remote control will flash and change. As soon as the correct code appears, you will hear a beep from your device and the air conditioner will turn on. At this moment, it is necessary to press any button on the remote control, the process of scanning the codes will be stopped.
Check the operation of the air conditioner with this code. If the commands are not executed correctly or some functions do not work, start the auto search for codes again until you find the code in which your air conditioner will work correctly.
Manual tuning takes less time. Find the code in the code table for your air conditioner model, there may be several of them. Press the "SELECT" button, while the code on the display of the remote control should blink once. Using the numeric buttons enter the code into the remote control memory and press the "ENTER" button, the remote control is programmed.
Check how the commands are executed by the air conditioner. If the air conditioner does not work correctly, try entering the remaining codes one by one. You can also cycle through the codes using the "TEMP +" and "TEMP-" buttons.
After entering the correct code, the air conditioner control panel is ready for operation. All basic functions will be available to you. From the remote control it will be possible to select the operating mode of the air conditioner - cold, heat, ventilation, automatic mode. You can set the desired temperature, adjust the fan speed and select the direction of the air flow.
