Thomson universal remote controls are a good alternative to using personal remote controls for each device. In order to start working with it, you need to configure it.
Instructions
Step 1
Turn on the device with which you want to set up the Thomson universal remote control. The device can be a TV, DVD-player, satellite receiver, etc.
Step 2
When setting up to work with a TV, press and hold the TV button on the remote until the LED starts flashing. Then use the number buttons to enter the code that matches your TV model. Typically, the instruction manual that comes with the universal remote contains tables with codes for different device models. If your specific model is not listed in the manual, try using codes for other devices from the same manufacturer. When typing, do not make long pauses between presses.
Step 3
If all the necessary settings for working with the device are contained in the remote control, the diode will blink on the TV being tuned. If it doesn't, try using a different code.
Step 4
Check the performance of the setting. Point the universal remote at the TV and perform one of the operations, for example, turn off and on, change channels, adjust the volume. If all operations are performed, the setting is correct.
Step 5
Another option for picking a code for a configurable device is automatic scanning. To do this, after turning on the TV and pressing the TV button, point the universal remote at the TV. Press the up arrow button to move to the next code (down arrow to move to the previous code). When you select a suitable code, the TV turns off. To memorize it, press the Enter button.
Step 6
Similarly, you can configure the universal remote to work with other devices. Instead of the TV button, hold down and hold down the button corresponding to the device to be set until the LED starts flashing. For example, DVD for DVD player, SAT for satellite receiver, etc.
