Copying a SIM card is necessary in the event that the old card is damaged or you want to make smaller cards for use in the phone simultaneously by two operators.
Necessary
- - computer;
- - programmer;
- - clean sim card;
- - Woron_scan 1.09;
- - IC-Prog 1.05D;
- - Sim-Emu 6.01.
Instructions
Step 1
Insert the SIM card into the phone and remove the PIN code request when turning on the phone. Then pull it out and insert it into the programming device. Connect it to your PC. Configure the application to copy the SIM card. Run Woron_scan 1.09, select the device type in the Card Reader - Phoenix Card menu, then set the generator port and frequency in the Setting menu.
Step 2
Then return to the main application menu, press the Ki button, then in the window that appears, click on the Start button. After completing the process of scanning the card, exit the program, save the result to a file. Open it with Notepad, find the IMSI and KI values there.
Step 3
Run IC-Prog 1.05D software to copy the SIM card. Go to the Settings menu, select the Programmer section, set the default value - JDM Programmer. Set the I / O Delay field to 30. Click OK. Then go to the "Options" section, uncheck the "Check after programming" checkbox, set in the "Check during programming" field.
Step 4
Restart the application. Go to the Settings menu, check the Smartcart (Phoenix) box. Then go to the "File" menu, item "Open". Select the file named SIM_EMU_FL_6.01_ENG.hex. Put the programmer in JDM mode, put all its settings in the PROGRAM PIC position. Select the desired type of microcircuit and click the "Program" button.
Step 5
Press the F4 key on your keyboard. Switch the programmer to Phoenix mode, set the following positions: for SIM CLOCK - 3.579 MHz, for SIM RESET - HIGH RESET, SIM DATA - in the SIM READER position. Select the type of microcircuit in the program. Then insert a blank card into the programmer, open the file SIM_EMU_EP_6.01.hex, press "Program".
Step 6
Wait for the process to complete, then configure map cloning. Insert the card into the phone, connect it to the computer, run the Sim-Emu 6.01 program. Enter the IMSI and KI codes in the Configure menu, Config. Pos.
