Satellite TV allows you to watch programs in very high quality using special satellite receivers (tuners). However, in order to enjoy high quality programming, you first need to properly install and configure your hardware.
It is necessary
- - television;
- - satellite antenna;
- - satellite receiver.
Instructions
Step 1
Run the cable from the satellite dish to the receiver and connect to the corresponding connector on the rear panel, usually labeled “IF Input” or “LNB IN”. Next, connect the receiver to the video input of your TV using the Scart connector or RCA connector. In order not to be mistaken, try connecting video to the yellow connector, and the audio to black and red. Refer to the letters on the rear of the receiver.
Step 2
Turn on the receiver. Refer to the instructions for your TV to tune to the correct channel. If you do everything correctly, you will see an image with the receiver's logo on the screen. A list of satellite channels to which you have subscribed will also be displayed here. You can usually also call up the list by pressing the "Menu" button, and then the "OK" buttons, which you will find on the remote control to the receiver or on the front panel of the device. Select the Russian language in the settings, and then set the appropriate parameters for the time and the output video signal. If the device asks for a PIN code, try entering the combination 1234 or 0000.
Step 3
Go to the satellite settings menu. Select the correct satellite and select the appropriate port. This is usually DiSEqC. From the instructions for the receiver, find out through which inputs the satellite converters are connected, and then set the appropriate values in the menu. Scan the satellite signal by pressing the corresponding key on the remote control or by selecting this item in the settings menu. Please note that modern TV models have the ability to auto-scan the satellite signal and various channels, so the signal transmission can start immediately after selecting the appropriate satellite. Remember to save your settings.
