A satellite dish is a set of devices that allows you to tune your TV to receive satellite channels. The most common are parabolic antennas. They come in various types and sizes, mainly used for receiving satellite TV, radio broadcasts and connecting to the Internet.
It is necessary
satellite antenna
Instructions
Step 1
Use the following methods to install and tune your Chinese antenna. Firstly, you can make a special L-shaped stand for it, fix it to the wall and attach the antenna to it. This ensures greater reliability of the mountings, stability and ease of adjustment. But there are also disadvantages: making a stand is a rather laborious process. You can also mount the antenna directly to the wall using the stand ring and clamps.
Step 2
Assemble the antenna, place it on a horizontal platform and tune to the satellite for maximum quality. Here you need to pay maximum attention to the converter, since it is not easy to get close to it on the wall. Drill a hole on the wall with a punch, 12 mm in diameter, 70 deep.
Step 3
Drill in the center of the future fixture. Drive a plastic plug into the hole and screw in a screw (10 x 140 mm). Screw a piece of cable to the converter, raise the antenna to the desired place, first put the rail on the central screw. Press it against the wall with a plate and place it on the screw with the center hole. Then pull it up against the wall with a nut.
Step 4
Set the angle, as well as the direction to the satellite by eye, by raising and lowering the plate reflector by turning on the screw axis. Change direction by correcting the length of the telescopic arm. Antenna pre-alignment data can come in handy here, since if you know the exact direction to the satellite, it is easier to find it from the wall.
Step 5
After that, drill holes in the wall, then fix the antenna using the standard kit to concrete. In the case of attaching the antenna to a cinder block or brick, purchase more authentic fasteners, because native may turn out to be short. If you constantly have to install antennas, remove the screw plate after attaching the rings with fasteners - they may come in handy in the future.
