A film for a tablet is a necessary accessory that will protect your device from mechanical damage. Even if you take great care of the device, after a few months, small but annoying scratches will appear on it. That is why it is recommended to stick on the protective film immediately after purchasing the tablet.
Necessary
- - the tablet;
- - protective film;
- - plastic card;
- - spray for the display;
- - viscose napkin.
Instructions
Step 1
Most people cannot stick the screen protector the first or second time. Motes of dust are visible under it, sometimes it is impossible to get rid of air bubbles. However, if you follow a number of recommendations, then such defects will not threaten your device. Better to give preference to quality films. They are not cheap, but if necessary, they can be peeled off, washed and glued again.
Step 2
It is better to stick the film in the bathroom by opening a hot tap. The water will attract dust in the air, saving you from a number of problems.
Step 3
Prepare the surface thoroughly. It is necessary to remove the greasy marks left after touching the fingers. It is recommended to use special LCD sprays for this. Spray a small amount of the spray onto the special rayon cloth that comes with the solution and wipe the display. Repeat the operation if necessary. It is very important to ensure that no marks or streaks remain on the screen.
Step 4
If you see dust particles on the screen, use paper tape. It can be glued to the display and torn off immediately. Paper tape does not leave sticky marks, but it perfectly removes dust.
Step 5
Place the tablet on a flat surface. Remove the film from the packaging. There are usually two protective coatings on the film. Carefully tear off Cover # 1 and turn over the film. Align the corners of the film with the wider side of the tablet, making sure it fits perfectly with the edge.
Step 6
Hold the film with your left hand so that it does not stick too quickly, and take any plastic card with your right hand. Use a card to smooth the surface of the pasted part of the film. If you see dust particles settling, put the card aside and glue and peel off the tape again in the desired area. Do not allow air bubbles to form.
Step 7
Continue gluing the film until you reach the opposite edge of the screen. Evaluate the result of your work. If the eye has let you down, and the protective film is crooked, if there are still air bubbles or dust under it, you can peel it off, rinse it under water, let it dry and repeat the whole procedure again.
Step 8
If you are satisfied with the result, peel off the second protective layer from the film. Start from the corner and gently pull the guard off.
