Film for the screen of smartphones and tablets today is a necessary accessory that protects the screen of the device from damage and abrasion. Many users prefer to carry their smartphone in a case or use protective glasses. But the film remains the most affordable and easiest way to protect the screen from scratches and scuffs. Let's take a look at a simple way to apply film to the screen of a device.
Necessary
- - screen film;
- - sharp scissors;
- - microfiber fabric.
Instructions
Step 1
Prepare your work area and thoroughly dust the area around. Any speck of dust increases the risk of dirt getting under the film.
Step 2
First of all, you need to prepare a film for a specific screen. If the film is released for a specific model, then you need to make sure that all the elements of the smartphone (camera, sensors, speaker) are really in the slots on the film. In the absence of them, you need to cut it yourself. Try on the tape in place.
Step 3
Wipe the screen thoroughly with microfiber. If you use a different type of fabric, the screen will attract all fine pile and dust particles, which will be very difficult to remove later. It is imperative to erase all streaks and traces of greasy fingers. It is necessary to achieve such a state when the screen is perfectly clean. At this point, cover it with a cloth and move on to preparing the film.
Step 4
Take the prepared film. Remove the first protective layer from it. It is not necessary to tear off the protective film to the end. Just start filming it. Next, start gluing the film to the smartphone from top to bottom. If the film is of high quality, then you need to start gluing it from the most difficult point - the location of the sensors and the speaker. With a lower quality film, we do the opposite.
Step 5
Slowly smooth the film from the center to the edges, gently peeling off the bottom protective layer. Smooth out the film with a cloth. Squeeze emerging bubbles from the center to the edges.
Step 6
If bubbles still form, then you can carefully peel off the film, remove the bubble and glue the film back. If hair or a speck of dust gets on the film, then it is useless to try to remove it. Any attempt to do this will result in the final loss of the film's appearance. Also, in no case need to pierce the bubbles with a needle.
