Signal jammers can be used in different areas. Dealing with a certain type of signal and knowing its frequency, it is possible to independently assemble this device. However, this should only be done if you have radio engineering skills.
It is necessary
radio engineering skills
Instructions
Step 1
Purchase an ordinary signal jammer, such as can be purchased at radio sales points in your city. Find out the frequency of the waves that you need to suppress and program this device. These can be various navigators, antenna signals, radios, telephones, and so on.
Step 2
In order to assemble the jammer yourself, use the following scheme: https://samodelnie.ru/skhema_glushylki.jpg. In this case, you can suppress any television and radio signal within a range of up to 10 meters. Please note that very powerful signal suppressors can ruin the technique.
Step 3
When assembling the device for signal suppression by yourself, please note that the loop coil L1 must not be on the same axis with the choke L2 and must be removed at a distance of more than 2 centimeters. Use a piece of wire 20-40 centimeters long as an antenna.
Step 4
When setting up, it is best to have a dielectric screwdriver in your toolbox. The inductor in this case should have about 10 turns, and the wire should have a diameter of 1 millimeter. Its frame should be 10 millimeters, and the choke should be wound on the MLT resistor 0, 5. Its nominal value is 100 Ohm, and the wire should have a diameter of 0.1 millimeter (100 turns).
Step 5
When using this device, please note that if you use it to influence someone else's equipment, you may be sued. If neighbors interfere with your sleep with loud radio or TV, use the legal response available: just call the police. According to the legislation of the Russian Federation, it is unacceptable to violate the silence mode after 23:00 in the evening. If you are sued for using a jammer, you will not only be required to pay a fine, but your equipment will also be taken away.
