Satellite television is gradually settling in the homes of ordinary Russians. Although the first time, not everyone succeeds in setting the channels correctly. And even from the second. But you won't invite specialists every time.
Instructions
Step 1
Connect the antenna cable to the receiver's LNB in jack. Connect the receiver to the TV (SCART input or RF out). If you are connecting the receiver for the first time, then on the TV screen will appear the section "Language setting" (by default, usually Russian), Click "Next". The section "AV-out setting" should appear. Change the AV-out settings as needed and click Next.
Step 2
Go to the "Search for channels" section. In the lower right corner of the section, there is usually a satellite tuning scale (signal quality and strength). In the event that you have not yet tuned the antenna to the satellite, do this using the scale on the screen. Select Search Type for Antenna, click Next.
Step 3
After that, the automatic channel search should start. At the end of the search, “Save found channels” will appear on the TV screen. Click Yes. Set the time and date according to the table that appears on the screen and click "OK". The channels of your satellite TV package are saved.
Step 4
There is another way to tune channels automatically. Press the "Menu" button on the receiver's remote control. The "Settings" section should appear on the TV screen. Enter your PIN (it is always 0000 by default). Select automatic search. The settings table should appear, where in the "Search type" section select "Quick search". Click Start Search. Answer “Yes” to the “Save channels” request.
Step 5
If you decide to use manual search, be extremely careful and careful. To do this, you need to know the values of the frequency and flow rate of the channels. Enter the "Menu", select the "Settings" section, and then - "Manual search". Leave all existing settings unchanged except for "Frequency" and "Flow Rate". After setting each channel, save it by clicking “Yes”. When finished, click Exit.
