There is nothing difficult in assembling the phone, but only on condition that during disassembly you did not damage any of the parts of the device, in this case it is best for you to contact the specialists.
Necessary
- - small Phillips screwdriver;
- - thin flat screwdriver;
- - a mild table knife.
Instructions
Step 1
Disassemble your phone after turning it off and removing the battery. Unscrew all visible fasteners, pull out the special plugs and unscrew the bolts under them, very often this is found in "clamshells". After that, proceed to open the phone case. Pry it up on one side and then on the other. Try to use less force as you can break the case mounts.
Step 2
Please note that some phone models can be fastened with special glue, here you will need a mild knife or a thin flat screwdriver. Place the phone on its side in a stable position (it will be better if someone helps you), set a screwdriver or knife along the line of connection between the parts of the phone case and lightly hit the tool with your palm, as soon as you feel that the phone opens, separate the parts with a knife.
Step 3
After opening the case, remember the sequence in which you disconnected the parts of the phone. Try not to damage the connections of the wires and cables of the screen with the microcircuit. In order to remove the circuit, unscrew the bolts, which are usually located on the sides and in the center. Be careful, if your phone has a Wi-Fi function, it is best not to disconnect the modem unnecessarily. The same goes for the phone's camera.
Step 4
Be careful when removing the speaker - it is usually soldered to the internal board of the phone, so during assembly you will have to somehow restore its position. Remove the keyboard, disconnect the fasteners of the remaining internal elements of the phone
Step 5
Reassemble the phone in reverse order. For the best memorization of the sequence, record a video of the disassembly, or simply copy your actions on paper.
