The phone is powered by firmware installed at the factory. Modern phones allow you to update the firmware at home using a computer.
Instructions
Step 1
To flash your phone, you need to sync your phone with your computer. As a rule, all the necessary components, namely the driver disk and the data cable, can be found in the package, otherwise you will need to find them yourself. You can find the data cable at your cell phone store. Make sure the connector matches your phone.
Step 2
As a rule, a disc with software necessary for synchronization will be sold in a set with a data cable. Otherwise, you will need to download it. Find out the make and model of your cell phone, then use search engines to find them. Pay attention to the official website of the manufacturer, as well as unofficial sites. On them you can also find a lot of information on personalizing your cell phone, as well as a large amount of adapted content.
Step 3
Install drivers, software and connect your phone to your computer using a data cable. To avoid adding a new device incorrectly, i.e. your phone, you must perform the actions in this sequence. After connecting the phone, make sure that the program "sees" the phone.
Step 4
Use the search engine to find the firmware and program for the operation. Use exactly the firmware that is right for your phone model. Using the wrong firmware for your model can ruin your cell phone. It is advisable to download and use software for which there is an instruction on the site.
Step 5
Start flashing only after making sure the phone is fully charged. Do not use the phone or disconnect it until the success message appears. Follow the instructions carefully.
