The Starline alarm system is equipped with two-way communication, as well as an extended range of service and security functions. It comes with a handy LCD keychain.
Instructions
Step 1
Connect the alarm to the car, then use the remote control to program it. Switch off the ignition of the car, then press the Valet service button on the remote control six times. Then turn on the ignition, six siren signals will sound, which indicate the entry into the alarm programming mode.
Step 2
Press the Valet button on the key fob to select a specific function. The number of clicks corresponds to the number of the selected option. Use the table to determine the function number
Step 3
For example, if you want to set the duration of the pulses sent to the central locking system for unlocking and locking, press the button once and set the required value using buttons 1 - 3 (see table). To set the state of the programmed function, press one of the remote control buttons within ten seconds after selecting the function.
Step 4
Set the delay for activating the sensors for doors, trunk and hood, for this press the service button three times and select the duration using the buttons (1 - 60 seconds; 2 - 5 seconds; 3 - 30 seconds; 4 - 45 seconds). To set the type of output to beep, press the system button eight times, then select the type: 1 or 2 - continuous mode, and 3 - 4 - pulse.
Step 5
Press the Valet system button eleven times to configure the anti-hijack engine lock. To activate this mode after pressing the brake, press 1, after activating the mode - 2 - 4. Arming mode with locking the doors. To do this, click the system key seven times, then press number 1. To disable this function, select buttons from 2 to 4.
Step 6
Exit the car alarm programming mode after setting the necessary Starline settings, to do this, turn off the ignition, or wait until the system exits the mode automatically. This will be confirmed by five flashes of dimensions, as well as a remote control signal.
