Nowadays, the presence of several SIM cards in a person is quite common, but it is inconvenient to take several devices with you. The easiest option is to use an adapter for two SIM cards, but with it you can use no more than two cards. Another option is to make a multisim card that supports up to 10 different numbers.
Necessary
- - SIM card programmer;
- - clean sim card;
- - application for calculating KI and firmware.
Instructions
Step 1
Insert the SIM card into the programmer, first disable the PIN code request when turning on the phone. Then connect it to your computer to flash your sim card. Then launch the Woron_scan 1.09 application, select the type of device for Card Reader to work, as well as Phoenix Card. Next, select the desired COM port, then the frequency of the crystal oscillator.
Step 2
To do this, go to the Card Reader menu, Settings. To start scanning, return to the main menu of the program, click on the Ki button, in the window that appears, click Start. If all the settings are correct, the determination process will begin. In terms of time, it can take from five minutes to one and a half hours, it all depends on the operator and the type of card.
Step 3
Exit the program upon completion of the process, save the result to a file, open it with any text editor, find the value of Imsi and Ki of your card in it. These values will be needed to flash a new sim card.
Step 4
Flash the SIM card. To do this, use the IC-Prog 1.05D application. Install the icprog.sys driver into the program folder (https://download.siemens-club.org/files/sim-clone/icprog_driver.zip). Right-click on the application file, select Properties, go to the Compatibility tab, then Windows 2000, click OK.
Step 5
Launch the Ic-prog program, go to "Settings" - "Programmer". Select the JDM Programmer device from the list. In the "Port" field, select the COM port to which the device is connected. In the "I / O Delay" option, select 30. Go to the "Settings" menu, the "Options" item. Go to the "Smart Card" tab, make sure the port value is selected correctly. In the Settings menu, check the box next to Smartcart (Phoenix).
Step 6
Restart the program. Then go to the File menu, open the file SIM_EMU_FL_6.01_ENG.hex. Switch the programmer to Jdm mode - for this move Sim Clock, Sim Reset, Sim data to Program.pic position. Select the desired type of microcircuit in the program.
Step 7
Press the "Program microcircuit" button. Next, put the programmer in Phoenix mode, set its following positions: Sim clock - 3, 579, Sim reset - High reset, Sim data - Sim reader. Press the programming button again.
