The receiver is a special device that allows the TV to receive a signal from a satellite and convert it into a standard TV one. Without this device, it is impossible to watch satellite TV.
It is necessary
- - television;
- - receiver.
Instructions
Step 1
Configure the Golden Interstar 7XXX series receiver by going to the “Installation” menu, select the name of the Eutelsat Seasat satellite, press the arrow to the right. Set the frequency value of LNB 10750 or 9, 7/10, 75. Set the value of the DiseqC parameter to Off. Turn on network search. Leave all other parameters by default, then click the "Install Programs" menu item and click the blue key, then "OK". Setting up the receiver on NTV is completed.
Step 2
Tune your Samsung receiver to NTV. To do this, select the “Installation” menu, enter the code 0000, then go to the LNB Settings item. Enter the satellite name EutelsatW4. Set the LO and LO frequency to 10750 respectively. Click OK and Exit. Next, perform the manual search option, find the EutelsatW4 satellite.
Step 3
Select the value of the parameter "TP number" so that the frequency contains the digits 12322. Enable the network search feature. After that, a signal should appear on the "Thermometer", as well as the name of the network. Click OK. After that, check for the presence of NTV-plus channels.
Step 4
Set up your Humax VA-ACE receiver to receive NTV + channels. To do this, go to the "Settings" menu, then select "Channel organization" and enter the code 0000. Select the "Arrange networks" option, delete the NTV network and all others. Click Exit twice. Tune channels.
Step 5
Select the option "Search for channels", then "Antenna tuning". Select the Eutelsat satellite. For manual search, enter the transponder frequency 12322, select the value of the "Polarization" parameter - "Auto", for SR - 27500, for FEC - ¾. Next, do a network search and click OK twice after it.
Step 6
Tune the NTV channels on the Humax VA5200 receiver. To do this, delete all existing channels. Go to the "Settings" menu, select "Channel organization", select "Networking" - "Delete all networks". To search for a channel, go to the corresponding menu item, select the "Antenna settings" option, set the Eutelsat w4 channel, set the local oscillator frequency to 10750, and the transponder frequency to 12322. Set the polarization value to 27500. Turn on the network search and add NTV channels in the receiver.
