How To Disassemble Sony Ericsson

Table of contents:

How To Disassemble Sony Ericsson
How To Disassemble Sony Ericsson

Video: How To Disassemble Sony Ericsson

Video: How To Disassemble Sony Ericsson
Video: Sony Ericsson W910i Disassembly Energizerx2 2024, November
Anonim

It is not difficult to disassemble a Sony Ericsson mobile phone. This will require some tools, care, adherence to a certain sequence. Disassembling Sony Ericsson allows you to replace individual defective parts. Particular attention should be paid to the removal of the housing during disassembly.

How to disassemble Sony Ericsson
How to disassemble Sony Ericsson

Necessary

Phillips screwdriver, size PH.0, flathead screwdriver, special disassembly tool similar to that used to disassemble the Nokia SRT-6 phone

Instructions

Step 1

We remove the back cover of the phone, take out the battery, SIM card and flash drive one by one. Unscrew the screws carefully.

Step 2

Using a screwdriver, gently squeeze out the keyboard. We remove the plastic plugs.

Step 3

We slightly extend the front of the case, unscrew the rest of the screws under it. Then we remove the front part using a special tool. We insert it into the gap between the upper and rear parts of the case, carefully draw it around the entire perimeter of the case. Thus, we will disconnect the latches, due to which the two elements are chained.

Step 4

We pry the connector with a screwdriver, and a matrix with a special tool. We remove these elements.

Recommended: