Almost every Russian music lover at least once a week, but watches clips that are broadcast on the Muz TV channel. For this reason (and possibly for a number of others) it is so important to be able to independently configure the broadcast of this signal.
Necessary
instructions for the TV, remote control
Instructions
Step 1
If you have cable TV, carefully read the instructions for setting up channels, and then return Muz TV to its original place (if the channel has already been tuned in). Tune this channel either automatically or manually.
Step 2
If these steps are unsuccessful, call (or visit) the service company that supports your television networks. There is a possibility that the reason for the disappearance (or absence) of the channel is a malfunction either in the system or in your TV.
Step 3
Call the service company also if, until recently, the channel was broadcasting absolutely normally, but at the moment it does not "want" to return to its original place. Immediately after contacting, wait for the employee to appear: he will have to check both the cable and the stability of the signal transmission.
Step 4
Do you have the most ordinary individual antenna? In this case, it simply cannot cope with the remoteness of the signal (it is located far from the TV tower). Try to pick up the signal by turning the antenna in other directions or by drastically changing its location.
Step 5
If you use a satellite dish, then familiarize yourself with its settings. If the channel has already been configured, most likely, the parameters have simply gone astray. If you are just going to install it, follow the instructions for your TV and satellite dish.
Step 6
If Muz TV has left its place, compare the current indicators with the standard ones. Go to the "Installation" menu (to do this, enter the code 0000). Immediately after that, select "LNB Setup". Here you need to specify the name of the satellite, the lower and upper frequency of the channel. Compare the indicators of the missing Muz TV and one of the functioning channels, and then write down the data. Then set the same values as the current channel.
