The channels on the TV do not always go in the sequence in which we would like to see them, and therefore there is a special manual tuning menu.
It is necessary
- - a pen;
- - notepad.
Instructions
Step 1
Examine carefully the buttons on the remote control and the front of the TV. If possible, read the instructions for your model and learn about the possibility of remote configuration. Also refer to the control diagram of your TV's setup menu; for the most part it is similar for most models, but there are exceptions.
Step 2
Open the channel list editing menu. Select an approximate sequence of channels, as you want to see it and rewrite its coordinates from this menu. Then switch to the next channel and do the same. Sometimes the setting takes place from the remote control, and sometimes without its participation from the front of the TV; everything here may depend on the model.
Step 3
Set up the channel sequence as you like. To change the settings of one or another channel, use the buttons to switch them in normal mode when the edit menu is open. Press the audio toggle buttons to navigate through the menu items. This type of control applies to most models, but in some cases it may not work.
Step 4
Apply the changes you made. Check the quality of the transmitted image of each channel. If it doesn't suit you. Re-tune the channels manually by changing the frequency a few positions and checking the results. If you still did not notice any changes, use the automatic tuning of the received channels. In this case, the sequence you set will be lost, but the reception quality will be the highest possible.
Step 5
If the reception quality is generally poor, then do not change anything. When reconfiguring channels, try to use the remote control if possible so as not to harm your eyes, as this can take a long time.
