A storage water heater is a medium-sized container that is used to heat and subsequently store hot water in those houses where there is no hot water supply through the water supply. Cold water enters the water heater, which is subsequently heated to the temperature you set, which you can adjust as you wish using a special regulator.
Instructions
Step 1
Of course, you can do all the work yourself, even if you do not have certain skills, and we will try to make your work more comfortable and faster.
Step 2
After unpacking the water heater, carefully inspect it for integrity.
Step 3
Install the water heater in the place where it is planned to be used in the future. It is imperative to install the water heater in the position provided by the manufacturer (vertical or horizontal).
Step 4
Supply electricity to the place of operation of the water heater, if it was not supplied there before. In this case, the size of the cable and the installation of the circuit breaker should be taken into account so that electrical overloads do not occur in the apartment or house during the operation of the device, since the water heater supplies a rather large power, more than 5 kW.
Step 5
Supply water to the water heater and ensure that prepared hot water is discharged from the heater. It is important here to consider the upper or lower connection the device provides.
Step 6
Test the connected device. After the connection of the storage water heater is working, it is necessary to drive water through it, checking the operation and making sure that all actions are performed with accuracy.
Step 7
Enjoy using the water heater. Remember, if your water does not meet the GOST standard, then a special filter for water purification must be installed at the water inlet to the heater.
