If you have purchased a home theater and you do not like the picture quality and sound, then you have set it up incorrectly. To make the sound and picture great, you need to take some steps to adjust their settings, and then you can enjoy watching your favorite movie.
Instructions
Step 1
The brightness setting is "brightness".
This function is for the black level. It should be adjusted so that blacks in the image are well reproduced.
Step 2
The contrast setting is "contrast".
This function is for the white level. Adjustments must be made so that the white color is clearly visible, but does not hide the details. For example, on the white dress of the bride, details were not hidden, that is, its design.
Step 3
Color saturation - "color / saturation".
This function adjusts the gain of the color gamut. It is best to adjust the color gamut using the color table, especially in the red spectrum. The saturation needs to be adjusted so that no color mixing occurs.
Step 4
The hue of the color is "Tint / hue".
This function is designed to convey the accuracy of the color correction. Using this function allows you to accurately reproduce tones and shades. This can be corrected for the face of the person in the image, bringing it closer to reality. Also, some models have a function that replaces the color shade - this is the "color temperature".
Step 5
Clarity, sharpness or detail - "sharpness / detail".
This function is for sharpening. It is necessary to increase or decrease the sharpness so that the image can be clearly seen, but there is no "noise". Noise or ripples will be very strong in the image in darker areas.
Step 6
Adjust the sound settings for your home theater.
Set up the left and right speakers, as well as the rear and front speakers, using the function selection.
Step 7
The center sound can be adjusted using the WIDE and NORMAL functions. You can adjust the signal delay when the center speaker is farther than the left and right speakers.
Step 8
On the receiver, using the volume controls, you need to level the sound so that from the point of view, the sound is distributed and is the same across all speakers. These settings are adjusted using the test mode.
