The tuner is an important part of the satellite TV system. Without this device, it is impossible to receive and broadcast TV channels. It should be configured correctly by strictly following the instructions.
It is necessary
- - television;
- - satellite tuner.
Instructions
Step 1
Select one of the connectors on the rear panel of the satellite tuner ("tulip", antenna output, HDMI, scart) and connect the receiver to the TV through it. On modern models, the required connector to which the tuner can be connected is always found, while in older models the connection is complicated by the presence of only an antenna output, and this affects the image quality.
Step 2
Connect the cable to the receiver after checking if the tuner is de-energized. Before proceeding with the configuration, you should carefully read the instructions.
Step 3
After connecting the satellite tuner to the antenna output of the TV, proceed with its setup. Menu => "antenna" or "tuning" / "installation-channel search" or "channel search". After that find the menu with settings: flash tone, LNB, positioner, 0 / 12V, DiSEqC. Make sure you have found the correct satellite.
Step 4
In the same menu, select a satellite and set the DiSEqC port for it. To connect multiple satellites, use a DiSEqC 4 port switch.
Step 5
Select the channel on which the tuner will show. Switching of TV channels will be directly carried out on the tuner itself. In manual mode, select the channel search function. Connect the receiver to the network beforehand. Check that the tuner display shows the date and not the clock.
