To receive a high-quality TV signal, you need to connect the TV antenna to the TV. You can connect the cable to the TV receiver using a special antenna plug.
It is necessary
- - nippers;
- - knife;
- - F-connector.
Instructions
Step 1
Purchase and prepare the necessary tools and connectors to connect to a television receiver. Use a wire cutter to flatten the end of the cable. Taking precautions, carefully cut 15 millimeters of the outer cable insulation. Do not damage the wires between the inner and outer insulation. Fold them back carefully and then remove the foil that is located around the insulation on the inside of the cable.
Step 2
Also carefully remove 10 millimeters of insulation around the inner core of the cable. Make sure that the multiple cores of the winding do not touch it, otherwise the signal quality will deteriorate significantly.
Step 3
Purchase an F-connector from any electronics store. Unroll it. Insert the prepared cable into the male connector. In this case, the outer winding is pressed against the body of the F-connector. The inner core will fall into the protruding part and will protrude about 3 millimeters. If the vein gets in the way, it can be bent. Secure the cable with the clamping ring. Connect the connector to the aerial socket on the TV.
Step 4
You can also purchase a plug with a cable lock by means of soldering. In this case, use a soldering iron and solder. Observe fire safety measures. Perform the operation in a well-ventilated area. For a hot soldering iron, use a special non-flammable stand. Do not place plugged-in soldering iron on the table.
Step 5
Prepare the cable as described above. Assemble the outer shell in a bundle on one side. Gently solder the inner strand to the center of the connector, and the winding twisted together to the outer strand. Check the soldering points for short circuits. Eliminate them if necessary. Put on the insulating bezel and connect the plug to the TV.
