More and more people are installing satellite dishes in their homes, providing access to satellite TV and satellite Internet. At the same time, customers of the service do not always have the opportunity to call an antenna installation specialist to their home, for a variety of reasons. In this article, we will tell you how to install a satellite dish yourself without the help of a wizard.
Instructions
Step 1
Check the complete set of the antenna and all its spare parts.
Step 2
Take the arc of the converter holder and install plastic plugs on both ends of it.
Step 3
Then, using two bolts, attach the metal support to the converter holder.
Step 4
Now take the feed (converter) and place it between the left and right holders and fix the holders with the feed on the arc of the converter holder using two bolts.
Step 5
After completing the above steps, take two metal clamps and install them in the swing arm. Attach a metal clip to the ends of each of the clamps, and then screw a nut and washer to each end.
Step 6
Take two long bolts and attach the swing arm to the support. Inside the swing arm, place two spacers, one for each bolt.
Step 7
Now take the dish - this is the antenna reflector. Fasten it to the support with four screws and four nuts from the back.
Step 8
Attach a metal L-shaped bracket to the wall with strong bolts, on which the plate with the converter will be attached.
Step 9
Insert the plastic plug into the bracket, and then use the support to place the fully assembled plate onto the bracket. Tighten the nuts of the swivel bracket, and also tighten the nuts on the clamps.
Step 10
Check how easily the cymbal turns in different directions. The assembly is complete - you can connect the TV, tune the antenna and check the signal reception quality
