For a touchscreen phone, a protective film is essential first. Typically, the display surface of such a device is scratched, leaving fingerprints on it. But getting a good protective film is half the battle, it must be carefully glued on.
Necessary
- - Nokia 5800 mobile phone;
- - protective film;
- - wet wipes.
Instructions
Step 1
Prepare everything you need: a mobile phone, wrapped film, wet wipes for phone care or special cleaning products. Thoroughly remove dust and all dirt from the Nokia 5800 screen. Pay special attention to this process - the display should be completely clean. Do not wipe it with alcohol and household cleaners, otherwise it will cloud.
Step 2
Next, open the packaging of the film. Usually, the adhesive side is covered with a thin piece of plastic - pull on the tab. Do not remove the entire layer at once, do not touch it with your fingers. Small dust particles can settle on the sticky side, and the film does not adhere well to the phone screen.
Step 3
After freeing up a small part of the adhesive side, begin to glue it. Gently place the film against the display and align with the top edge of the phone screen. Peel the rest of the foil off the polyethylene as it sticks.
Step 4
Smooth out the part to be glued with the card supplied in the kit, or take a credit card if there is no special cardboard in the package. Do not put your fingers on the screen.
Step 5
If small bubbles remain, do not touch them - they will disappear over time. If you didn't manage to stick the film straight the first time, don't be discouraged. Pry it by the corner and re-glue it - it does not stick to the screen tightly. If the quality of the product is good, the film can be washed with water and glued again.
Step 6
Do not stick the film too close to the edge, leave a small gap. If in the process of gluing a few dust particles got inside, do not remove such a film and do not wash. Better you do not glue it, and after a while the dust particles will be less noticeable. In the process of using the phone, a good quality film can be removed and cleaned - washed under running warm water.
