There are several ways to disable installed motion sensors, the main task is to approach them imperceptibly. It is also necessary to know in advance their exact location in the room.
It is necessary
- - insulating tape;
- - varnish in spray.
Instructions
Step 1
Disconnect the motion sensor by disconnecting them from the power source. This is the easiest way. However, most of them are battery operated and have no wires, in this case you only have to break the device. Also, the option with de-energizing is also bad in that the disconnection of the sensor can be detected, in this case you are unlikely to be able to remain unnoticed.
Step 2
Use a can of translucent varnish-spray, spray the motion sensor, after which it will work, but will not send signals about your actions in the room. Also pay attention to the type of sensor, it is quite possible that its sensitivity lower to the floor may be weaker, this is typical for pet owners who, when installing the sensor, were guided by its height.
Step 3
If the motion sensor uses infrared radiation, cover it with electrical tape. Do not use tape or other objects for this purpose, as it will not be possible to turn off the sensor. The effect will be the same - the sensor will function and the movement will not be noticed. It is best to double-layer it.
Step 4
Also pay special attention to the direction of motion sensors - not all models of sensors work using direct radiation, many of them can change the angle of inclination in almost any direction, so you will also have to take this point into account. It is best to study the direction of the sensors during the daytime.
Step 5
Do not use any of these actions for illegal purposes, moreover, none of these methods give a 100% guarantee that they will not work. Do not use light objects to cover the sensors, also do not try to illuminate them, in most cases this will not work. Also, first learn how to determine their location and direction.
