There are many types of chargers. A charger called "frog" is used to recharge phone batteries. "Frog" is simple and easy to use, has no wires. Plugs into a 220 volt outlet. In order to charge the phone battery using such a charger, you need to perform a few simple steps.
Instructions
Step 1
Turn off the phone and remove the battery.
Step 2
Press the "frog" on the clothespin on the charger. The device will open.
Step 3
Insert the battery into the device so that the two terminals match. If the charger has four terminals, then you need to use two, which are located on the side.
Step 4
Press the TE button (left). If the CON LED lights up green, then you have connected everything correctly. If not, check that the terminals are connected correctly.
Step 5
If, after making sure everything is connected correctly, the CON LED does not light up, it is possible that the battery is completely discharged. In this case, plug in the charger with the battery for five minutes. After five minutes, check if the CON indicator is on. If yes, then everything is fine. If it still does not light up, then check the presence of voltage in the network and the integrity of the charger.
Step 6
Connect to the network. The CH indicator should light up or start flashing.
Step 7
The battery is charged when the left FUL indicator on the charger comes on.
