Chinese cell phones, like their prototypes from well-known companies, are equipped with separate power buttons. Before turning on such a device, you must install the battery, two SIM cards and a memory card.
Instructions
Step 1
Unpack your phone. Find the battery. Position it so that its contacts are in the same corner as the springs in the compartment. Press it against the springs, then insert it into the compartment.
Step 2
Put on the cover and slide it up until it clicks. If required, additionally secure it with two screws on the sides.
Step 3
Slide the side rubber covers for the memory card and first SIM card slots. Install them in these slots. Do not put too much effort into doing this - if the installation fails, the card may just need to be turned over. Use a microSD memory card.
Step 4
To insert a second SIM card, slide off the rubber cap on the top of the case that says HDMI. In fact, the fake phone does not have an HDMI connector, but there is a second card holder. Then replace all the plugs.
Step 5
Both SIM cards and the memory card should be inserted into their designated slots until you hear a click. To remove the card, you need to press on it with the nib of a regular fountain pen, and a second click will be heard. After that, it will come out, and if not, you need to carefully pull it out with tweezers.
Step 6
Connect the charger to the socket located at the bottom of the case. Plug it in and a stylized image of a charging battery will appear on the screen shortly. Press the power button located at the top of the case. Hold it until the phone turns on. Make sure it detects both SIM cards. Format the memory card if necessary. The location of the menu item that allows you to do this depends on the phone model.
Step 7
Wait until charging is complete and start using the device. If the charger is lost or malfunctioning, you can usually use a charger that is designed for original Nokia phones (with a thin plug).
