In order to properly connect the electric stove, the safety rules and the norms for the technical operation of the housing stock must be followed. Failure to comply with these standards, the manufacturer may void your warranty. Incorrect connection of the electric stove threatens, at best, with a short circuit of the electrical wiring, at worst with a fire.
It is necessary
- - instructions for the electric stove;
- - electric stove;
- - copper three-core wire;
- - tester;
- - socket;
- - panel machine;
- - screwdriver;
- - pliers.
Instructions
Step 1
First, read the instructions - in order to choose the right installation location and determine how much wire you need and what section. Next, remove the board from the packing material and inspect for damage or any chips. After all, the aesthetic appearance of the slab is also an important element of our life.
Step 2
The old stove must be removed in order to prepare the place for the installation of the new one. First, check the apartment panel for connection. The lead-in cable to the apartment must be copper, and its cross-section must be at least 6mm², the lead-in machine must be 40-50A. The wire to the electric stove must be separate - no other devices can be connected to it !!! There should be three lived in the cable: for zero, ground and phase. Zero and ground must be connected to different pads, ground to the body, zero to a bus isolated from the body. Connect the phase to an automatic machine with a nominal value of 32-40A.
Step 3
Next, note that the other end of the wire has a three-prong 25-38A socket. To plug the electric cooker into the network, buy small white sockets that are installed in the wall. Assemble the fork. Purchase the cable for connecting from the outlet to the stove PVA 3n4 (three-core for four sections). It is best to leave 2 meters of cable to ensure comfortable servicing of the cooker.
Step 4
Now connect the plate to the cable and insert the plug into the socket. Pay attention to the color of the wire: black is the phase, blue is zero, yellow-green is ground. The ground is connected to the shield body and then to the plate body. In this case, the machine in the dashboard must be turned off !!! Now check if everything is connected correctly: for this, take a tester and examine the stove. The first thing to test is the lack of contact between phase and ground. To do this, set the 2MΩ mode on the tester - if the infinity sign is shown, then everything is connected successfully, you can safely use the stove.
