Inkjet cartridges are quite expensive and consumed quickly. There is a way to extend the life of the cartridge - refueling using special ink. How to refuel the HP MP252 printer yourself - we will consider in the article.
It is necessary
- - MFP Hewlett Packard MP252;
- - 4 disposable syringes, 5 ml each;
- - paper tape;
- - toner for the printer.
Instructions
Step 1
First you need to turn on the printer and put it into maintenance mode. First, turn on the printer as usual. There is a recess on the top cover for easy opening. Pull this indentation up and open the compartment to gain access to the paint compartment.
Step 2
Now click on the button with the image of tools on the control panel. The ink cartridges should slide along the guides into the middle of the compartment.
Step 3
Let's start with the black cartridge. It is located on the right. We press on the gray lid to access it. We carefully take it out of the compartment.
Step 4
We unscrew the lid of the jar of black paint. A foil membrane should be located under it. We do not tear it off, but simply pierce it with a needle and draw about 5 ml into the syringe. Then remove the sticker from the top of the cartridge, under which there is a recess. We pierce it with a needle and insert it all the way. Slowly and carefully inject the paint into the cartridge until the paint starts to ooze slightly from the top of the hole. As soon as it started, we stop injecting the paint. Wipe off excess paint from the top of the cartridge. We take paper tape and glue the hole. Now you can put the cartridge back where it was and snap the gray cap back.
Step 5
We remove the color cartridge in the same way. A color cartridge contains 3 inks at once. We take our own syringe for each paint. We also pierce holes for each of the paints. We look at what paint is in which hole. We fill them with the appropriate paints. We glue and insert the cartridge into place.
Step 6
Now it remains to close the cartridge compartment and press the maintenance button again to exit the printer maintenance mode. After that, you should carry out a test print to make sure that the printer is working.
