Setting up a TV usually consists of adjusting TV channels, geometry, color, brightness and other parameters. In modern TVs, many of the system parameters are located in the service menu. They are opened for regulation by dialing a special code from the remote control.
It is necessary
TV "Vityaz"
Instructions
Step 1
Go to the TV service menu to configure Vityaz TV. To put it into standby mode, press the AV button on the front panel, turn on the TV while holding this button. Alternatively, short-circuit the pins of the XN1 connector on the switched on TV. To configure certain parameters, select the required items in the service menu. Exit from it is carried out in the same way, using the AV button.
Step 2
Set the following values to adjust the position of the picture on the TV screen: HSH (horizontal shift) set to 24, vertical tilt (VS) to 24. Vertical picture size (VA) set to 58. These settings are necessary to adjust the TV picture.
Step 3
Adjust the color correction on your TV. To do this, set the values of the parameters WR, which is responsible for the correction of red, WG - the correction of green and WB - blue colors - 32. Next, adjust the brightness signal of the TV. Make sure the Ys parameter is set to 14, Yn to 8, Yp to 0, and Yo to 0. This parameter sets the delays for SECAM, NTSC, PAL, and external sources, respectively.
Step 4
Tune the channels of the Vityaz TV. To do this, press "Menu" on the remote menu, then select "Channel setup". Set the option "Auto tuning". To rearrange the order of the TV channels, select the Sort option. To view two channels simultaneously using two built-in tuners, use the "Frame in frame" menu item.
Step 5
Go to the "Teletext" menu item to set up the reception of encoded information. Select "Brightness", "Contrast", "Saturation" from the menu. The value of each parameter can be adjusted using the volume buttons on the remote control.
