Often, for a cell phone to work correctly, you just need to correctly reflash it, and for this it is not at all necessary to put a certain amount of money in a service center. It is enough to carry out a few simple manipulations - and the phone is back in working order.
Necessary
Firmware programs for phone or smartphone, Crack for Phoenix 2.5a (230 kb), Phoenix 2004 (67.4 MB), Diego_3_06 (35 MB) and cable drivers
Instructions
Step 1
We start installing the programs in the following order: Diego_3_06.msi, then just run (without installing) Crack.exe and install Phoenix 2004. We receive a message from the system that an error has occurred and then we arrange both windows (with an error and Crack.exe - installation) and click on Retry while installing our Crack.exe. If the program requires the replacement of all files, we agree with it. We try to carry out the installation promptly in order to prevent a repetition of the error. Ignore the various warning windows!
Step 2
The installation is complete, and two messages appear - Add Phoenix icon to Desktop (check the box), but do not check Open the log! Then we restart our computer by clicking on Finish.
Step 3
After rebooting your PC, launch Phoenix and immediately minimize its window. Collapsed? Now we start to install phoenix.exe. Have you installed it? Good. The computer now prompts you to restart, but you shouldn't agree.
Step 4
Now we will install the cable driver for your phone. Next, copy the files with the.adl extension to the folder where Phoenix was installed. You need to find those on the C: drive in the program files. The program for flashing is ready. It should be remembered that it only works until the first reboot.
Step 5
Next, launch Phoenix. Click on File => Connections, and then on Add. A window will appear, select Manual, then Next, then USB and click on Finish.
Step 6
Now it remains to connect our phone to the computer (via a cable) and wait for the PC to detect the phone and install the drivers. Then go to Phoenix and click on File => Scan Product (Ctrl + R).
Step 7
So, directly flashing. Unpack the flashing that we downloaded earlier and click in Phoenix at the top of Flashing => SW Update, then in the window that appears, click on Image file - Firmware file (*. C0R) and select PPM File - Language pack (*. vXX, - XX package number.). Then click on Start. When the Test mode message appears, without disconnecting the device from the PC, you need to turn it on and close the Test mode message.
Step 8
Reboot again, and finally a message stating that the flashing was successful. Now our cell phone can be safely rebooted and formatted.
