Choosing the right gimbal model is really difficult. Problems with power grids vary. Instability protection equipment must comply with the specified interference.
Necessary
- - computer;
- - tester;
- - Voltage regulator.
Instructions
Step 1
Determine the characteristics of potential problems in your electrical system. Measure the voltage - it can be high or low. Pay attention to power surges and dips and phase distortion. Consider the characteristics and capabilities of single-phase stabilizers. Consider the device's output power, operating range. Pay attention to the ability of the stabilizer to work in extreme conditions, do not forget about the dimensions. Study the connection diagram of the stabilizer, the power of the connected device. This information is in the instruction manual or the passport of the device.
Step 2
Stabilize the entire electrical system in your home. Use a combination of three or single phase models. The choice of stabilizers depends on the total power of all devices in the apartment. Calculate the parameters of the electrical equipment. For accuracy, measure the equipment with special devices - a tester or multimeter.
Step 3
Consider the full capacity of the devices when calculating the metrics. This value is indicated in volt-amperes (VA). Choose a stabilizer so that the power reserve is at least 20% of the total system load. The technique will work in a sparing mode. You won't have to buy a new stabilizer after a few months of active operation. When choosing a stabilizer, consider its main functions: - voltage stabilization;
- protection against power surges;
- protection of equipment against short circuits. Some models of single-phase stabilizers have such parameters as the ability to change the protection threshold, setting the output voltage to 220V, warning by sound, protection against overheating, self-diagnostics. The price of such stabilizers is higher than the cost of simpler models.
