Installing a satellite dish opens up access to a huge number of television channels, the existence of which you had never even imagined existed. But what if, among the hundreds and more channels, the one you need most is not found? It turns out that the situation can be corrected.
Instructions
Step 1
Not the best in terms of material costs, but an effective way to increase the number of TV channels is to add another plate. Fix the additional antenna next to the existing antenna, adjust it and connect the linear converter to the switch (disk) to which the operating antenna is connected. This way, the additional signal will be received by your TV after proper adjustment.
Step 2
There are other ways to increase the number of satellite channels. After you have recorded the signal from the satellite, carefully scan the satellite transmitter (transponder) you need using the receiver.
Step 3
After that, decide on the channel you are interested in and the satellites that broadcast it. In Russia, most cymbals receive signals from Hotbird, Sirius and Amos. There is a list of channels on the Internet that each of them broadcasts - tune in to the one you need.
Step 4
Then find the satellite channel settings in the transponder list. This information is also available on the Internet. If the search for the channel or satellite you need was unsuccessful, enter the following information into the search engine: lingsat 4W or 5E, 53E, 75E, 40E, etc. The tables on the lingsat will provide you with all the information you need to set up a channel.
Step 5
Next, go to the tuner menu of your satellite dish and select the section where the settings for the satellite head and receiver are located. Select the transponder you need from the list or add a new one that you found on the Internet using the settings.
Step 6
Then you can start scanning with the remote control. In case of any difficulties, you can use the tips at the bottom of the screen. So, a menu with several scanning modes appeared in front of you - manual, blind search, auto scan, etc. If you have never dealt with this, turn on auto search and find the desired channel. In case of failure, enter the settings of the required transponder into the list “manually” and re-scan.
