Tricolor is one of the first satellite TV companies in Russia. To become a subscriber of this company, you need to install and configure the appropriate equipment, namely a satellite dish. There are many companies offering satellite dish tuning services, but many users, in order to save money, prefer to do everything with their own hands.
Instructions
Step 1
First of all, it is necessary to determine - where will the plate itself be installed?
When choosing an installation site, it is necessary to take into account that the dish should be directed to the satellite, which is located at 36? east longitude, for this point the plate at the sun between 13:00 and 13:30 Moscow time. There should be no obstacles on the way between the dish and the satellite, such as houses, trees, etc. The plate should be installed on the outside of the building, for example, on a wall, on a balcony or on a roof.
Step 2
Antenna tuning begins with setting the azimuth and elevation angle of the antenna, the azimuth can be set using a compass, the setting of the angle depends on the design of a particular antenna.
Step 3
Connect the cable from the converter to the digital terminal. Connection is made when the receiver is turned off.
Step 4
Connect a digital terminal to your TV. If you use a SCART, RCA tapa cable, then press AV on the TV remote control, in the terminal menu, activate the "Received signal level". Sequentially press the buttons - "Menu", "Settings", OK (code 0000), "Manual search", OK. The indicator of the received signal appears on the TV screen.
Step 5
Turn the plate mirror until the indicator on the TV screen shows 85%. The antenna must be turned in a horizontal plane at very short intervals (1 - 2 mm), stopping for 10 - 15 seconds each time. If there is no result, then it is necessary to raise the mirror of the plate by 5? up and repeat the operation, thus raising the plate until you achieve the result. It must be remembered that the plate must be firmly fixed to the bracket.
Step 6
After the adjustment is completed, it is necessary to tighten the adjusting nuts and press the Exit key three times.
